Can you go over the procedure for programing each zone for water, high and low temperatures on a GC3. I am running firmware 3.1.1.
Sure, see below:
Sensor Type: 08 – 24 Hour Auxiliary Alarm
Equipment Type: Flood
Equipment Code: (1065) 2GIG Flood Sensor
Serial Number: Learn – Tamper Sensor
Equipment Age: New
Sensor Loop: 1
Voice Descriptor: As desired
Sensor Reports: Enabled
Sensor Supervised: Enabled
Sensor Chime: As desired
Sensor Type: 08 – 24 Hour Auxiliary Alarm
Equipment Type: Temperature
Equipment Code: (1065) 2GIG Flood Sensor
Serial Number: Learn – Tamper Sensor
Equipment Age: New
Sensor Loop: 2
Voice Descriptor: As desired
Sensor Reports: Enabled
Sensor Supervised: Enabled
Sensor Chime: As desired
Sensor Type: 08 – 24 Hour Auxiliary Alarm
Equipment Type: Freeze
Equipment Code: (1065) 2GIG Flood Sensor
Serial Number: Learn – Tamper Sensor
Equipment Age: New
Sensor Loop: 3
Voice Descriptor: As desired
Sensor Reports: Enabled
Sensor Supervised: Enabled
Sensor Chime: As desired
Thanks Jason
So it is ok with this particular device to use the same serial number (i.e TXID) for all 3 loops.
I did not know you could repeat the TXID number when programing 3 new zones?
Yes, that is how Honeywell Loops function. Each uses the same serial, and the function is determined by the Loop number if multiple functions exist.