2GIG GC3-SP2 paring

I’m sure I’m being a dum dum here, but for the life of me I cannot get the new SP2 to pair with the GC3. I attached a picture of the situation.

BTW - thanks to the shipping department for the BLAZING FAST ship. I think I received it ~2 days after ordering. Impressive.

Tom

Happy to help! Looks like that may be in a different pairing menu in the GC3.

To clarify, on a GC3 with 3.1 or later, go to the Installer Toolbox, select System Configuration, then select Keypads.

Choose an unused keypad zone and enable it, choose equipment code SP2, then Pair.

Hi there. We have had some trouble pairing a SP2. Once going through to choose to pair on 3.1 as above, the GC3 shows as listening, but the secondary display just is waiting to hear the key. Both are connected to WiFi.

Do you have any ideas on what to do here? Thanks!

The instructions do not mention it, but the SP2 will ask for a key after entering the IP address, just leave it blank and tap the check-mark.

Ah ah! That would make it easier. We’ll give it a try.